Module Reset Instructions 1 – Launch ncs expert and load the expert profile 2 – Press F1, then F3, choose your car chassis from the list and press ok. Expert Mode Profile Ncs Expert TestExpertmode Profile Ncs ExpertExpert Mode. _ RECODE/RESET affected modules to enable FTMġ) For my car i had to reset BDSC, CAPPL (PRE LCI NAV CCC) AND KOMBI. **TO WRITE TO ANOTHER MODULE, -F1 (SG/SGEN), THEN F3, EXECUTE JOB. ECU) 4) SELECT CHASSIS 5) CAS, (VIN SHOULD POPULATE), OK 6) F2, ENTER FA 7) SELECT CHASSIS, AGAIN 8) CLICK ON $2VB, HIT DELETE KEY ON KEYBOARD AND PRESS OK 9) F6, BACK 10) F4, PROCESS ECU 11) SELECT CAS, AGAIN 12) F2, CHANGE JOB, SELECT FA_WRITE 13) F3, EXECUTE JOB 14) F1, SG/SGEN, SELECT NFRM 15) F3, EXECUTE JOBįor e90 328xi 2008 i had to recode VO’s for NFRM and CAS Press F3 or click the buttom ZCS/FA ECU.Then choice your vehicle body stype,here i choice E60,select CAS click OK.

When I first start and try to load profile, I get the following, no plain 'expertmode'. Launch the NCS Expert software.Click File>Load profile>Expert Mode,then click OK. Coding is not my deal, but am willing to learn. Almost all of my knowledge on the e90 is around the engine and what not. If anyone could send me your basic NCS Expert profiles and tell me how to load them into the NCS Expert, it would be much appreciated. ** Disconnect RDC Module above battery in trunk behind insolation ** 1) NCS EXPERT, FILE, PROFILE, EXPERTMODE 2) F1 (vIN, ZCF/FA) 3) F3 (ZCS/FA F. Got all files from here, NCS Expert version 4.0.1, Daten file copied into proper folder. 2007 BMW E90 335i 0.00 2008 bmw x5 0.00 Need NCS Expert Profiles & other.

Ncs expert e90 profile